Combined Punching And Shearing Machine Made In China

1. Before start-up combined punching and shearing machine, check whether the transmission parts, connecting screws and pin shafts of the punching and shearing machine are loose. Whether the electrical grounding is intact.

2. Lubricate all parts before work, start up and test run for two to three minutes, and put into operation only when there is no problem.

3. Overload is not allowed, and punching and shearing of quenched steel is strictly prohibited.

4. Wear gloves and labor protection articles during work, and sandals and slippers are strictly prohibited.

5. During punching and shearing, always refuel the punching tools to prevent the upper and lower punching tools from skewing.

6. Pay attention to the safety of fingers during feeding, especially when the sheet metal can not be pressed by the last presser foot, punching and shearing is prohibited.

7. It is strictly prohibited to disassemble, disassemble and calibrate the cutting edge and punching die when driving. It is not allowed to knock the die, shear blade and other parts.