Punch and Shear Machine
Code For Safe Operation Of Punching And Shearing Machines
Code for safe operation of combined punching and shearing machine
1) Punching and shearing steel plate, round steel, square steel, section steel, etc. can be carried out at the same time. However, two kinds of steel shall not be cut at the same time.
2) It is forbidden to cut quenched steel and process beyond the capacity of the equipment.
3) The cutting tool and cutting edge shall be kept sharp. If the cutting edge becomes blunt or cracks, it shall be replaced in time. When cutting steel plate, round steel, square steel and section steel, it must be compacted.
4) When cutting or punching, it is forbidden to touch the machined workpiece surface, measure the workpiece, and directly clean the leftover materials by hand.
5) The operator must stop when leaving the machine tool. When starting again, check that the original position of the handle of each part should not change.
6) It is not allowed to shear laminated sheets, narrow sheets and short sheets that are not tightly pressed.
7) During feeding, the finger must be 200mm away from the knife edge, and special tools shall be used for small parts.
Demand table loading...
|