Lubricate All Parts Of The Thread Rolling Machine Before Operation

Lubricate all parts of the thread rolling machine before operation, start up and test run for two to three minutes, and put it into operation only if there is no problem. When it comes to mechanical wire rolling machine, wire rolling machine is a kind of wire rolling machine equipment integrating multiple functions such as metal shearing, punching and plate shearing. It has the advantages of simple operation, low energy consumption and low maintenance cost. The body of qa32-8 wire rolling machine tool is analyzed, the stress and strain data of the dangerous position of the machine tool are obtained, the key structural factors affecting the equivalent stress and deformation of the bed are found out, and the improvement scheme is put forward. The equivalent stress of the bed is 61.8mpa, which is far less than the allowable stress of the material; The deformation of the bed is only 0.0847mm, far less than the previous deformation of 1.587mm. Through the actual measurement of the stress at the dangerous load position of the bed before the improvement and the y-direction deformation of the tiger mouth of the bed after the improvement, the correctness of the ANSYS calculation model and analysis results are verified.