Circular Gsa Cutter
Operation Guide For Flame Circular Gas Cutter
Operation guide for circular gas cutter:
1. Knock the positioning hole on the steel plate surface first;
2. Install the radius rod of the cutting circle on the machine body, put the positioning pin into the positioning eye, tighten the positioning screw according to the radius of the cutting circle, and raise the positioning pin at the same time to make the guide wheel on one side of the positioning pin leave the steel plate, and use the front and rear rollers on the other side of the gas cutting machine to rotate around the center of the circle for cutting;
3. When cutting small circles, place the positioning pin on the same side of the cutting torch; when cutting large circles, place the positioning pin on the opposite side of the cutting torch.
Demand table loading...
|