China Sichuang Machinery Manufacturing Co., Ltd

Gas Profiling Cutting Machine

How To Operate Gas Profiling Cutting Machine

Author£º Date£º2022/9/14 10:13:20 Visits£º

Operating Steps of gas profiling cutting machine

1. Operators must wear gloves, safety helmets and goggles before using the equipment.

2. Clean all combustibles in the cutting area and splash area.

3. Check whether the valves of oxygen cylinders and acetylene cylinders leak, and separate the two cylinders by more than 500mm to avoid explosion due to backfire and gas leakage. The oxygen cylinder and acetylene cylinder shall be placed vertically and firmly, and shall not be placed upside down.

4. Connect the air supply line and power line, and place the air supply line and power line in the position where the cutting spatter cannot be splashed.

5. Before use, adjust the appropriate air pressure safety valve as required, and the working pressure is 0.5 ~ 0.7MPa.

gas profiling cutting machine

6. When using the gas regulator, check whether the thread of the regulator is damaged and whether the connection with the gas cylinder is sealed. Oil, sewage and dust are not allowed at the connection end of the regulator, so as to avoid entering the gas regulator and blocking the airway.

7. During use, profiling templates shall be installed according to different workpieces. Generally, the cutting torch shall be more than 100mm away from the machine body. If necessary, isolation measures shall be taken.

8. According to the different thickness and material of the workpiece, adjust the flame of the gas and cutting torch, and walk at an even speed, so as to avoid breaking the flame, forming bubbles and foaming, and damaging the workpiece.

9. Always pay attention to adjusting the regulator to avoid backfire. If any, cut off the cylinder immediately to avoid harm.

10. After the work is completed, the cutting slag shall be cleaned, the surrounding environment shall be cleaned, the gas source and power supply shall be cut off, and the workpiece, profiling template and cutting machine shall be placed properly.



Demand table loading...
Your needs£º
Your E-mail£º     Check code£º