Noodle Machine
Common Faults And Troubleshooting Of Noodle Machine
Common faults and troubleshooting of noodle machine:
1. The panel cannot be connected normally?
Due to improper adjustment of the roll gap, there will be plate breaking and residual plate phenomenon. The previous panel is thin, the next panel is thick, and the demand for the next panel is large, so the plate will be broken, and on the contrary, the residual plate will be left. Therefore, when adjusting the roll gap, reduce the gap between the lower pair of rolls to make it uniform.
2. Panel running edge or uneven thickness on both sides of the panel?
It is caused by the inconsistent gap between the two ends of the roller. Therefore, adjust the gap between the two ends of the roller to make it uniform.
3. Is the panel and noodles curved?
It is the scraper and cutter between rollers, and the comb knife can be adjusted in place if the installation angle is too large or the edge of the comb knife is opposite.
4. Does the panel stick to the roll?
It is because the surface is bad, the moisture is too large or the scraper bolt is loose.
5. Can't break the noodles?
If the cutting edge of the section is inconsistent with the bottom plate, the cutting edge of the section can be trimmed and adjusted to the right position.
6. Broken noodles?
It is because there are impurities in the flour (the residue left in the flour bucket last time) or the flour is uneven.
Demand table loading...
|