China Sichuang Machinery Manufacturing Co., Ltd

Rebar Cutter

Current location£ºHome >> News >> Construction Machinery >> Rebar Cutter

The Best Steel Bar Cutter Is In China

Author£º Date£º2022/10/12 21:07:53 Visits£º

(1) The worktable for receiving and feeding materials shall be level with the lower part of the rebar cutter, and the length of the worktable can be determined according to the length of the processed materials.

(2) Before starting, check and confirm that the cutter is free of cracks, the tool holder bolts are fastened and the protective cover is secure. Then turn the belt pulley by hand, check the gear engagement clearance and adjust the cutter clearance.

(3) After starting, it shall be idling first, and the operation can be started only after all transmission parts and bearings are checked for normal operation.

(4) When the machine does not reach the normal speed, the material shall not be cut. When cutting materials, the middle and lower parts of the cutter shall be used, and the reinforcement shall be tightly held and aligned with the cutting edge for quick input. The operator shall stand at the side of the fixed blade and press the reinforcement forcibly to prevent the end of the reinforcement from popping out and hurting people. It is strictly forbidden to hold the reinforcement with two hands on both sides of the blade and bend over to feed.

rebar cutter

(5) It is not allowed to cut the reinforcement whose diameter and strength exceed those specified on the mechanical nameplate and the red burned reinforcement. When cutting multiple bars at one time, the total sectional area shall be within the specified range.

(6) When shearing low alloy steel, replace the high hardness cutter, and the shearing diameter shall meet the requirements of the mechanical nameplate.

(7) When cutting short materials, the distance between the hand and the cutter shall be more than 150 mm. If the hand holding end is less than 400 mm, the short end of the reinforcement shall be pressed or clamped firmly with a sleeve or clamp.

(8) During operation, it is strictly forbidden to directly remove the broken ends and sundries near the cutter by hand. Non operators are not allowed to stay around the steel bar swing and the cutter.

(9) In case of abnormal operation, abnormal noise or skewed cutter, stop the machine for maintenance immediately.

(10) After operation, cut off the power supply, remove the sundries between the cutters with a steel brush, and clean and lubricate the whole machine.



Demand table loading...
Your needs£º
Your E-mail£º     Check code£º