Gear Selection And Transformation Of Rotary Tiller

Gear selection and transformation of rotary tiller

(1) When the micro tiller is working in the field, it is recommended to select gear I and gear II at most, otherwise it will cause overload and affect the service life of the micro tiller.

(2) When the micro tiller needs to change the high-speed gear during operation, the clutch must be disengaged first, then the shift lever must be moved, and then the required gear must be engaged.

(3) When changing from low gear to high gear, the accelerator shall be increased to increase the speed before shifting. When changing from high gear to low gear, the accelerator shall be reduced to reduce the speed before shifting, so as to not only drive smoothly, but also avoid damaging the gear.