Magnetic Gas Pipe Cutter
Magnetic Gas Pipe Cutter
Magnetic Gas Pipe Cutter video
|
Demand table loading...
|
Magnetic Gas Pipe Cutter Description
The magnetic pipe cutting machine has two groups of four permanent magnetic wheels, which automatically cut around the steel pipe through the transmission mechanism. The cutting process can adopt oxygen acetylene flame or oxygen propane flame. It is suitable for cutting and beveling seamless steel pipes of various specifications with a diameter of more than 108mm. Due to the adsorption of the magnetic wheels, the cutting machine can also perform all-round multi-directional cutting at various spatial positions, such as horizontal, vertical, horizontal and vertical, Cutting and beveling can be completed at one time. Using this cutting machine can improve efficiency, ensure quality and reduce labor intensity. The magnetic pipe cutting machine is suitable for cutting and groove cutting of various seamless steel pipes in factories and mines such as petroleum, chemical, shipbuilding, power generation machinery construction and installation.
1. During the use of the cutting machine, always use a brush to remove the iron filings, garbage and other dirt adhered to the roller.
2. The steel pipe surface (the part where the magnetic wheel travels) shall be cleaned of iron filings, rust and other dirt with a wire brush
The steel pipe with wet paint shall not be cut to prevent the paint from sticking to the roller and reducing the magnetic attraction.
3. During cutting, it is necessary to prevent the oxygen acetylene gas pipe and the power cord from catching other objects, which may cause the cutting machine to fall down and be damaged.
4. After the cutting machine is used up, it should be placed on the magnetic protective iron plate and stored in a dry place to avoid rust and demagnetization of the roller.
5. The decelerating part is lubricated with molybdenum disulfide No. 9 grease. It should be replaced every half a year. Before replacement, it should be cleaned with carbon tetrachloride,
Then apply lubricating grease.
6. After the magnetic wheel has been used for a certain period of time (generally about one year), if demagnetization is found, the adsorption force is reduced, and it can be removed
The magnetic wheel group is magnetized again.
7. In the process of use, if it is found that the downhill impulse of the machine is too large, open the left upper cover and the right upper cover to move the left and right brackets
Line adjustment, worm and helical gear meshing clearance, to ensure cutting quality.
Magnetic Gas Pipe Cutter News
- 2022-11-16 Working Principle Of Gas Magnetic Pipe Cutting machine
- 2022-09-14 Preparation Before Operation Of Magnetic Gas Pipe Cutter
- 2022-09-07 Maintenance Of Magnetic Gas Pipe Cutter Tube Cutting Machine
|
Demand table loading...
|